Tamerica-products TCC-1200 Manuel d'utilisateur télécharger pdf (Page 4)

common temperature/speed setting for typical uses. Wait another 10 ~12 minutes before starting the

lamination job.

Film Thickness

Temperature

Speed

1.5 Mil (38 Micron)

110°C (230°F)

3 Mil (75 Micron)

115°C (239°F)

5 Mil (125 Micron)

125°C (266°F)

10 Mil (250 Micron)

150°C (302°F)

LAMINATING PROCEDURES

1. Release the handle from the locked position and insert the handle pin into the “MIN” notch to

engage the rollers. The user can now start laminating as the machine starts feeding in film.

2. To put the lamination temporarily on hold without turning off the machine, the user can release

the handle and reinsert in any of the notches from 3/16” and higher. This will separate the rollers

and stop the motor from feeding more film.

3. Pull the handle back to the “MIN” setting to reengage the rollers and resume the lamination job.

(2) ONE-SIDED LAMINATION

LOADING THE FILM

Unpack only the upper rod. Install nylon or thermal film on 1” or 3” cores by following an

adapter---film----adapter sequence onto the rod and fit the adapters onto the paper core. Leave equal

lengths of the rod out of each end. Use the guide to position the roll of film then tighten the screw on

the adapter to secure the roll film. Load the rod on the laminator.

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Tamerica-products TCC-1200 Manuel d'utilisateur Page 4