45” Wide Format Hot and Cold Laminator
H. AUTO SHUT-OFF FUNCTION This machine is equipped with an auto shutoff feature. The following is a step by step diagram of its operation:
I. FILM SLITTER This machine is equipped with safety film slitter in the back of the machine for trimming film in between sheets of laminated materia
6 WARRANTY This machine is guaranteed against defects in materials and workmanship by the Manufacturer for a period of one (1) year from the dat
OPERATING INSTRUCTIONS TCC1200 1 IMPORTANT SAFEGUARDS When using electrical machines, basic precautions should always be followed to reduce the r
3 HOW TO USE A. LAMINATING FUNCTION (1) TWO-SIDED LAMINATION LOADING THE FILM This machine has the capability of loading laminating film wit
common temperature/speed setting for typical uses. Wait another 10 ~12 minutes before starting the lamination job. Film Thickness Temperature Speed
THREADING THE FILM Refer to threading diagram for one side lamination found on the machine’s right side panel. Do not mistake the reinforcing bar for
(3) COLD LAMINATION LOADING THE FILM Unpack the upper and lower supply rods. Install cold laminating film with liner on the upper rod by following
LAMINATING PROCEDURES 1. Make sure the print is aligned and set properly onto the mounting board. 2. Release the handle from the locked position
C. SAFETY SHIELD AND FEED TRAY SENSORS Both the safety shield and feed tray activate sensors that allow the bottom roller to feed film when they ar
needed to be set for this application. Simply remove the liner from the board, carefully and evenly align the print and set it onto the adhesi
Commentaires sur ces manuels