Tamerica-products V2000-Pro Manuel d'utilisateur télécharger pdf (Page 6)

1. Check if the binding edge guide is aligned

– Insert an assembled top and bottom

strip with a sheet of aligned & punched

paper. Adjust the binding edge guide by

sliding the guide to the edge of the paper.

2. Place the bottom strip (textured side faced down) on the

strip recess. Make sure that the locator hole is attached to

the locating pin. Lay the sheets to be bound on top of the

bottom strip. (Please refer to top photo for correct

document assembly) The correct size of top strip is

determined by using the scale on the backstop to

determine the thickness of the document to be bound.

3. Insert the correct top strip firmly on

to the document to be bound.

4. Place the pressure bar firmly on the document. The ready

light will turn on indicating that the machine is ready for

binding.

5. Pull down the handle firmly on the document. After holding

down the handle for at least 8 seconds, the light will turn off

indicating that the binding cycle is complete. You may hear

cutting of the pins during the binding cycle. Raise the handle

and then pressure bar. Slide the bound document towards

yourself to cut off pins that may still be slightly attached to the

strip.

Binding

1 2 3 4 5 6 7 8

Pas de commentaire

Tamerica-products V2000-Pro Manuel d'utilisateur Page 6